Comments
Patch
===================================================================
@@ -78,9 +78,8 @@
} else if (CONFIG_GX2_PROCESSOR_MHZ == 300) {
DEFAULT_FBDIV = 18;
} else {
- printk(BIOS_ERR, "Unsupported GX2_PROCESSOR_MHZ setting!\n");
post_code(POST_PLL_CPU_VER_FAIL);
- __asm__ __volatile__("hlt\n");
+ die("Unsupported GX2_PROCESSOR_MHZ setting!\n");
}
/* clear the Bypass bit */
@@ -186,7 +185,7 @@
/* You should never get here..... The chip has reset. */
post_code(POST_PLL_RESET_FAIL);
- while (1);
+ die("CONFIGURING PLL FAILURE\n");
} /* we haven't configured the PLL; do it now */
===================================================================
@@ -59,9 +59,8 @@
wrmsr(GLCP_SYS_RSTPLL, msrGlcpSysRstpll);
/* You should never get here..... The chip has reset. */
- printk(BIOS_ERR, "CONFIGURING PLL FAILURE\n");
post_code(POST_PLL_RESET_FAIL);
- __asm__ __volatile__("hlt\n");
+ die("CONFIGURING PLL FAILURE\n");
}
printk(BIOS_DEBUG, "PLL configured.\n");
Use die() to assure the processor can't wake up from an interrupt. Signed-off-by: Nils Jacobs <njacobs8@hetnet.nl> This was suggested by Peter and Stefan. Thanks! I also included the same patch for Geode LX and added a second die() to Geode GX2 at the same place as in the LX code. I boot tested it on my Wyse S50 and it seems to work. Thanks, Nils.